冷再生施工和机械租赁业务
筑路架桥,奉献社会;以人为本,不断创新

服务热线

18264104888

新闻中心

首页>>新闻中心冷再生机机械在天气寒冷之前要维护好

冷再生机机械在天气寒冷之前要维护好

来源:http://www.tclqgc.com/ 日期:2022-07-22 发布人:
实际上我们在使用冷再生机过程中会有大量的灰尘落到再生机的表面,包括施工中沾污的油迹等污染物,影响外观事小,更为严重的是成为腐蚀的诱发因素,等等一些问题会出现,那么您知道天气寒冷之前要如何对其进行维护吗?
In fact, during the use of the cold regenerator, a large amount of dust will fall on the surface of the regenerator, including pollutants such as oil stains stained during construction, which will have a small impact on the appearance. What is more serious is that it will become an inducer of corrosion, and so on. Do you know how to maintain it before the weather is cold?
清洗外表,是工程机械冬季保养要点之一。清洗工程机械的柴油机、底盘、工作装置的外表,除垢、除油保持再生机的外观整洁。清洗时严禁用高压、高温的水枪来冲洗防水要求较高的部位(特别是电器部分),以免造成电器部分的损坏。
Cleaning the appearance is one of the key points of winter maintenance of construction machinery. Clean the appearance of the diesel engine, chassis and working device of the construction machinery, remove dirt and oil, and keep the appearance of the regenerator clean. During cleaning, it is strictly forbidden to use a high-pressure and high-temperature water gun to wash the parts with high waterproof requirements (especially the electrical parts), so as to avoid damage to the electrical parts.
冷再生机租赁
保养转子及其罩壳和滑靴。检查转子是否有水泥结垢等,及时清理灰尘,对需要割除、焊接的刀具及时更换;清理转子罩壳上的灰尘,并在施工结束收车时将转子罩壳垫起地面5-10公分,防止雨雪的浸蚀;检查滑靴,对已经磨损的滑靴部分进行补焊,螺纹处应涂抹黄油防锈。
Maintain the rotor, its casing and slippers. Check whether there is cement scaling on the rotor, clean the dust in time, and replace the cutting tools that need to be cut and welded in time; Clean the dust on the rotor housing, and cushion the rotor housing 5-10 cm above the ground when the vehicle is collected after the construction to prevent the erosion of rain and snow; Check the slipper, repair the worn part of the slipper, and apply grease on the thread to prevent rust.
减速机油位及减速机油的检查:
Inspection of reducer oil level and reducer oil:
冷再生机租赁厂家提醒您,先切断电源,等待减速机冷却后打开放油螺塞,检查油是否充满,避免漏油,取油样,检查油色泽及粘度指数,如果油明显浑浊,建议尽快更换。新减速机使用后(500-1000)小时更换新油(将内部污油冲干净),其后每使用1500小时需要更换油一次,但是在使用过程中,仍需要检查油的质量,若油有老化、变质情况要随时更换。
The rental manufacturer of the cold regenerator reminds you to cut off the power supply first, wait for the reducer to cool, open the oil drain plug, check whether the oil is full to avoid oil leakage, take an oil sample, and check the oil color and viscosity index. If the oil is obviously turbid, it is recommended to replace it as soon as possible. Replace the new reducer with new oil (flush the internal dirty oil) after use (500-1000) hours, and then replace the oil every 1500 hours. However, in the process of use, it is still necessary to check the quality of the oil, and replace it at any time if the oil has aging and deterioration.
冷再生机机械在天气寒冷之前要维护好的相关内容便是这样了,如果您想要更好更长久的使用设备,就要好好遵守保养维护事项,关注我们http://www.tclqgc.com让您了解更多。
This is the relevant content of the cold regenerator machinery to be maintained before the weather is cold. If you want to use the equipment better and longer, you should observe the maintenance matters and pay attention to us http://www.tclqgc.com Let you know more.

阅读/ Recommended reading

  冷再生机和路拌机在路面施工及维修中各有其独特的功能和适用场景,它们之间的主要区别体现在以下几个方面:  Cold recycling machines and road mi...

冷再生机出租对道路施工行业的影响 2024-12-18
如何选择冷再生机出租服务 2024-12-16
冷再生机出租:道路施工的新选择 2024-12-11
冷再生机租赁在土壤稳定中的应用与优势 2024-12-09

产品/ Recommended products